|February 21st, 2004, 07:08 PM||#1|
tailing light unit
on the corner tail light (not the one on the trunk lid)... there are 3 holes. 2 for the 2 bulbs (brake and signal) but what is the third hold for?
I see wires going in, but i have no idea what those wires are for? ??
does anyone know?
|February 21st, 2004, 08:01 PM||#4|
it's for sedan.
it only has 2 bulbs in that unit
O~! btw. formatsee, do you still remember :
- the resistance (Ohm)u used for yr tail light LED ?
- the resistance (OHm)u used for brake light LED?
(ya, it's the same LED, but you use a smaller resistor for the brake light?? right?
- and what type of LED do you use?
(size 5mm, 10mm ??)
(viewing angle ???)
Thank you sooo [email protected]!!!
Last edited by Icen; February 21st, 2004 at 08:20 PM..
|February 22nd, 2004, 07:54 PM||#7|
Join Date: Jul 2002
Location: San Jose
haha i asked that same question here:
Cliffnotes: Move the black resitor box to the new taillight, or else your brake light wont light up when you brake.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|