need help with system!! - Honda Accord Forum : V6 Performance Accord Forums
Ribbon Banner

Go Back   Honda Accord Forum : V6 Performance Accord Forums > GENERAL DISCUSSION > GENERAL AUTO DISCUSSION > AUDIO - VIDEO - ELECTRONICS
Register FAQ Members List Calendar Mark Forums Read Insurance
V6Performance.net is the premier Honda Accord Forum on the internet. Registered Users do not see the above ads.
Reply
 
LinkBack Thread Tools Display Modes
Old August 4th, 2008, 06:57 PM   #1
neeeeeeeeeeeeeeeeeeeeeeel
 
implayaz9's Avatar
 
Join Date: Sep 2005
Location: LA/ORLANDO
Posts: 6,808
Send a message via AIM to implayaz9 Send a message via Yahoo to implayaz9
need help with system!!

here is the deal. i have this

1 10inch sub
1 4 channel amp
components

i just wanna swap to my new setup which is 1 mono amp and 1 12 inch sub. but i cant achieve this as the system place which installed my stuff in LA wired in such a way that the speakers are powered thru the amp. so what do i need to acheive to keep the 4 channel amp running to all the speakers inside and to run the 1 channel amp and sub? what would i need? and do i need to rewire the whole car or?.

and another thing.

my fuse went out and when it did the front speakers didnt work but the rear speakes worked. does this mean that the 4 channel amp is only connected to the front speakers? if this is the case how should i go about doin this? AND WHAT DO I NEED?
implayaz9 is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old August 16th, 2008, 07:54 PM   #2
Registered User
 
1greek4u's Avatar
 
Join Date: Jul 2006
Location: Chicago
Posts: 642
Don't know if this comes to you too late but I'll give you advice anyway.

Sounds like your rear speakers are connected to your head unit. So on your four channel, channels 1-2 were wired to your fronts and channels 3-4 were bridged to your sub.

Turn your gains all the way down before you do this.

The best thing to do in this situation is to bridge that 4ch to your front speakers. You'll need two RCA Y-splitters and hook them up to each end of your RCA. Hook up the left side to channels 1-2 and hook the right side to channels 3-4.

Now you want to bridge the speaker wire. Hook up the left side speaker wire to the outside positive (+) and outside negative (-) of channels 1-2.

Do the same thing with the right side speaker wire, outside + and outside -. Most amplifiers will have a little diagram by the terminals to illustrate which speaker outputs to use.

Reset your gains. You won't need to turn them up very high because you just doubled the power to your front stage. Careful when you're setting these because you are adjusting front/rear for left/right so try to get them the same so both channels are the same volume.

Good luck
-Dennis
1greek4u is offline   Reply With Quote Quick reply to this message
Old September 6th, 2008, 01:52 AM   #3
7th Gen ACcord
 
xjdMb16a2six's Avatar
 
Join Date: Sep 2002
Location: socal
Posts: 3,671
hey neel, too bad you're not in socal anymore. i could've redo your system. so it sounds like you're trying to add another amp. you're going to have to buy a new amp kit with distributors and redo the wires. you're also going to need to get another line converter for the mono amp.
xjdMb16a2six is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Reply


Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Honda Accord Forum : V6 Performance Accord Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Chapter
Choose your AV6 Chapter Location
Ride
What do you drive?
Insurance
Please select your insurance company (Optional)

Log-in


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On