FS: 7th gen Coupe LED tail light boards

[sy272004]

since i scraped my led tail project after i made board ill try to sell them. TAIL LIGHTS NOT INCLUDED, you would need to open yours up to insert this boards. any questions please ask

brightness (500-600 lumens from each tail light, a lot brighter then your tail lights)


specs
bottom row 16*4 leds
middle row 15*4 leds (turn signal or whatever) would need to be wired separetly
bottom row 14*4 leds

Philips lumileds red/orange 60/50 degree leds running at 60ma (22ohm 1/2W resistors)
running from 12V regulator board that controls brightness of running lights









time spend on this about 60-80 hours if not more

whats included
2 boards
2 controllers (one for brake/running light and one for turn/running lights)


give me an offer is somebody interested. currently redoing wiring on this

[flylow2cre8]

How difficult is it to install this into the housing? Am I looking at superglue or mounting tape and splicing to get this thing to operate? And can I see a pic of the 2 controllers?

[stran]

Pmed.

[sy272004]

Originally Posted by flylow2cre8

How difficult is it to install this into the housing? Am I looking at superglue or mounting tape and splicing to get this thing to operate? And can I see a pic of the 2 controllers?

you would need to open housing(or somehow cut the bottom off and then reglue it. (i used dremmel to open them couse they sonic welded together). superglue or hot glue would work i guess. splicing probably not. if i have wires i can wire them up for pretty much plug and play

2 of those

Originally Posted by stran

Pmed.

replied