|September 28th, 2006, 12:45 AM||#1|
I have two sony xlpods subs for sale. They are the red ones and they are 12 inch subwoofers. Seliing them for $30 a piece plus shipping. Let me know. Also for sale is an alpine 4 channel amp....shoot me some offers on this amp.. Not sure how much to sale it for. But it is al plus shipping
|September 28th, 2006, 03:42 PM||#4|
Here goes the info on it
Crossover: The internal crossovers are 18dB/octave fixed at 80Hz. The crossovers may be set for high-pass, low-pass, or full range operation. There are two separate crossovers, one for channels 1 & 2 and one for channels 3 & 4.
Speaker Level input: There is a four channel speaker level input harness compatible with nearly any model head unit, factory or aftermarket.
Multi Mode: A subwoofer and two stereo speakers can be powered simultaneously by each set of amplifier channels using Alpine's Multi Mode. An outboard crossover (or two) is required for this and is not included.
MOSFET Power Supply: The DC-DC converter uses MOSFETs for more efficient operation.
Bass Boost: The bass boost circuit boosts channels 3 & 4 8dB at 50 Hz
Left Side Of Amplifier:
Channel 1 & 2 Crossover Switch: Allows you to select high-pass, low-pass, or full range crossover operation
Channel 3 & 4 Crossover Switch: Allows you to select high-pass, low-pass, or full range crossover operation
Bass Boost: On/Off, boosts 8dB at 50Hz, affects channels 3 & 4
Channel 1 & 2 Gain: This variable gain control allows you to match the output level of the head unit, 200mV to 4V
Channel 3 & 4 Gain: This variable gain control allows you to match the output level of the head unit, 200mV to 4V
Inputs and Outputs
Left Side Of Amplifier:
Channel 1 & 2 Line Input: Gold-plated stereo RCA jacks
Channel 3 & 4 Line Input: Gold-plated stereo RCA jacks
Line Output: Gold-plated non-fading stereo RCA jacks
Speaker Level Input: 4 Channel molex plug input for included harness
Right Side Of Amplifier:
GND (ground): Gold-plated terminal strip, 0.332" wide
Battery: Gold-plated terminal strip, 0.332" wide
Remote: Gold-plated terminal strip, 0.332" wide
Speaker Outputs: Gold-plated terminal strips for channels 1, 2, 3, and 4, 0.332" wide
Continuous Power Rating (measured at 14.4V, 20 Hz-20 kHz):
Bridged into 4 Ohms: 100 watts x 2
Per Channel into 2 Ohms: 50 watts x 4
Per Channel into 4 Ohms: 40 watts x 4
Bridged into 4 Ohms: 180 watts x 2
Per Channel into 4 Ohms: 75 watts x 4
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|