Accord V6 Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
I'm currently in the process of upgrading my front brakes to the brembo brake conversion on the 7th gen Accord I have the brembo brake calipers the outer tie rods from the TL spindle knuckle but do I need the lower control arm from TL ? I heard conflicting statements that I need the lower control arm so I can have a proper alignment and that the lower control arm is the exact same as the Accord?
Bicycle part Tool Auto part Font Bicycle drivetrain part
 

· Registered
Joined
·
10 Posts
No you don't but it's recommended the TL ball joints are 3mm bigger in diameter it's been a while though I don't remember if the ball joint is part of the lower control arm or the spindle


Sent from my SM-S908U using Tapatalk
 

· Registered
Joined
·
32 Posts
Discussion Starter · #3 ·
No you don't but it's recommended the TL ball joints are 3mm bigger in diameter it's been a while though I don't remember if the ball joint is part of the lower control arm or the spindle


Sent from my SM-S908U using Tapatalk
Thanks , your upper control arms look like they have been replaced and from what I've seen you have to replace your upper control arms the TL are shorter then the Accord or the camber will be off on the alignment.
 
1 - 3 of 3 Posts
Top