Accord V6 Forum banner

Custom Tweeter Pod *PICS*

1K views 7 replies 7 participants last post by  Kiet 
#1 ·
Hey all I just though I would share these tweeter pods in progress. They are pretty good so far. They just need to be redyed to match the interior a little better. And the GAP you see in the lighter picture towards the top is not there when I have a little double sided tape on. Tell me what you think. I wanted something clean and close to stock looking and I think its pretty close.



 
See less See more
2
#4 ·
Good job on the sail panel! :D One of the more difficult process is to blend or get an even texture for a surface that's not smoothed to begin with. It's normally just easiest to sand the entire piece for the sake of uniformity. After you have match painted the piece, I'm sure it won't be noticeable.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top