Accord V6 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
1,263 Posts
Discussion Starter #1 (Edited)
***1 owner j30a1 engine 120k***
*Timing belt, water pump and seals done at 95k
*J30a1 engine. Runs great (no j30a1 intake or fuel injectors)
*Thermal block head to runners gaskets
*J30a1 TB, alternator, starter, ac compressor
*J32a2 intake (needs to be port matched to use on j30a1 engine)
*J32a2 270cc stcok injectors (fuel rail needs to be modified to use on j30a1 engine)
*Ingalls stiffy torque dampner (only used for approx. 10k) new its $150

***$375***

*Will part out*

This engine is ready to drive or you can use it as a project build while you drive your car. Its been out of the car for about 2 months. Went w/ a j32a2 motor swap so dont need it anymore. I bought the car new and have been the only owner so its been kept up w/ on maintenance.

Thanks,

Brad
941-740-0255
 

·
Registered
Joined
·
76 Posts
Bro honestly your not going to get much for the j30 motor, trust me i tried when i replaced my j30 with one from a junkyard. It's a motor nobody really wants. Your probably better off parting the motor out
 

·
Registered
Joined
·
1,263 Posts
Discussion Starter #7
Bro honestly your not going to get much for the j30 motor, trust me i tried when i replaced my j30 with one from a junkyard. It's a motor nobody really wants. Your probably better off parting the motor out
Yeah, your probably right. It would be a good project motor to build so you dont have down time by building the motor in your car.
 
1 - 8 of 8 Posts
Top