Accord V6 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1 (Edited)
Hey guys I have the polished neuspeed front lower tie bar for sale. It fits fine on my V6 even with my obx headers. I just had to put in 2 washers on each side. Makes a big difference.
Has a couple of scrapes on it but no big deal.

Retails for $170. Asking $110 shipped

pictures are located at
http://www.acurainspired.com/gallery/showalbum.php?aid=889&uuid=1015
 

·
Registered
Joined
·
25 Posts
Discussion Starter #3
Thanks, I fixed the link anyways so they work now
 

·
Registered
Joined
·
494 Posts
Will this fit on an AV6? I've never seen this before... Does it make a noticeable difference?
 

·
Registered
Joined
·
25 Posts
Discussion Starter #5
Yes it does fit the V6, but if you have aftermarket headers you will need 2 washers on each side for extra clearance, thats what I did. Makes a noticable difference, more noticable then the upper strut bar I think
 

·
Senior Moderhater
Joined
·
6,110 Posts
yeah, neuspeed stopped these last time I checked and there were sites, and people on ebay selling it for 24.99 for new ones. And they all made sure to say it WONT fit the v6, I wish I knew it did it the v6, I would had purchased one a 24.99
 

·
Registered
Joined
·
25 Posts
Discussion Starter #8
I dont think they were selling neuspeed bars for 24.99 on ebay, might have been a homemade bar. They are still selling REAR lower tie bars on ebay for $24.99.
The front one is listed as not fitting v6 b/c it touches the headers, but with 2 washers on each side it fits fine. If you want I can email you a picture of it on a V6. I didn't get a chance to take a pic of it on my car, but have a pic of TL with this bar on with washers.
 
1 - 8 of 8 Posts
Top