Accord V6 Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
203 Posts
Discussion Starter #1
im doing a component install this weekend on my accord. today is my last day, im so cramped by time. so im hoping some of you can help me save some time by explaining how to get out the dash tweets, and how to run a wire down from the tweet and through the door from the woofer. please get back to me asap, thanx so much.
 

·
Registered
Joined
·
380 Posts
a little late, but the tweets just pop up - use a small flat head and remove the tweet (and "cross-over" in one piece). as for the wire, if you have round 'fish-tape" that works good, or just a blunted coat hanger, go through the boot, try not to remove it from either end cause it's hard to get back in.
 

·
Registered
Joined
·
380 Posts
how much room is there on that plate that covers the window? I want to put my tweets somewhere (if not in the dash) and would like them flush mount how i had them before. they are 1" tweets from some kicker 6.2 components. (6's obviously going in the door, not sure what to put in the back - havnt picked out a 5 ch amp yet, or a sub... just starting out with this car)
 
1 - 9 of 9 Posts
Top