Accord V6 Forum banner

1 - 16 of 16 Posts

·
Super IcyAccord
Joined
·
2,512 Posts
Discussion Starter #1
Selling off some extra parts I dont need, pictures will be posted if there is interest.

Parts can be used for a rebuild or any j-series build.
I have a J-series graveyard in my garage, and I really need to clean it out. If parts are not listed just ask and I will see if I have any lying around. I am located in GA, but am willing to ship items.

I do NOT however have any extra throttle bodies or intake manifolds other than the ones I have listed.



  • $350 QTY:6 Brand New Odyssey Pistons & Rings
    Pulled from a Brand new J35a4 block with 0 miles on it fresh from the factory.
  • $25/ea QTY:12 CL-type S J32a2 Pistons
  • $60/ea QTY:12 CL-type S J32a2 Rods / Wrist Pins / Bearings / End Caps
  • $300 CL-type S J32a2 Heads (front & rear) Complete 70k
    everything in tact, minus the cams seals which are ~$10
  • $100 Brand new oil pan, drain plug & washer
  • $80 J32a1 Intake Manifold / Runners / Fuel Rails
    make your j30 look like a j32 :p slightly increased intake volume
  • $make offer J32a2 Crankshaft, may need to be machined back to spec
Theres more but im tired of typing...
Would prefer to sell in sets of 6, to make things easier

I am willing to take reasonable offers, key word... reasonable.

:up:
 

·
03 Accord 6/6, 09 Audi A4
Joined
·
201 Posts
Do you happen to know the volume increase/decrease of the j32A1 intake mani over the j32a2 or j30a1 for that matter would you? Thanks. GLWS
 

·
Super IcyAccord
Joined
·
2,512 Posts
Discussion Starter #5
no fabbing is needed, everything you need is included, you just need to take off your throttle body and swap it onto this one.

you have to remove the runners but that isnt hard. everything else is bolt on and go.
 

·
Hella Functional
Joined
·
4,960 Posts
I'm looking for the front & rear plenum cover and the top manifold cover
 

·
Super IcyAccord
Joined
·
2,512 Posts
Discussion Starter #8
^ i may actually have some laying around, let me go check today after school.

im 99% sure i have a front / rear plenum cover. not too sure about the manifold cover.
 
1 - 16 of 16 Posts
Top