Accord V6 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I just finished putting in a tranny that I got from a p.o. . When shifted into R it takes about a second and then it engages. If you touch the gas it literally launches like if you dumped the clutch. When I took it up the street, it did the same thing from 1st-2nd and then it wouldn't shift above 2nd. From 1st - 2nd it felt like a drag car. It actually got some rubber.

What could I have connected wrong or cross connected? Or did someone sell me a bum tranny?

I don't think I can go through doing another tranny. I started this last fall. Overall, it probably took me about 6 full days to do it. Not bad in the driveway. these trannys don't grow on trees either.

Any help is very much appreciated
 

·
Mr. Detail
Joined
·
1,161 Posts
Check your fluid level, make sure its correct, check shift solenoids. May get more response on acurazine in their 3rd gen forum, lots of information on our transmissions there.
 
1 - 2 of 2 Posts
Top